Blown hemi duster street driven - $45,000

Listed By cadilacjoe
Contact (856) 278-0662
Blown hemi duster street driven  for Sale $45,000
$45,000 Get Financing
Private Seller - cadilacjoe
sicklerville, NJ
Message Seller + Add to Favorites
Report This Ad

Item Details

Ad Number183934995


This car has sat for a year. Clean the carbs and drove on and off trailer .
Be glad to give you the 4-1-1. This may be more than you need for track tuning, but you may as well know it, for future reference. 


4.500 bore x 4.150 stroke 
Ross forged blower pistons, 7.7:1 comp. 
C&A moly rings 
Manley H-Beam rods with ARP 2000 bolts 
Eagle 4340 crank 
Blower is 11% overdriven, makes about 11 or 12 lbs. boost max 
Megablock is O-ringed, see detailed spec sheet in car 
MP heads bowl-ported, has receiver grooves 
SCE .033 thick copper head gaskets 
Carb calibration, see spec sheet inside car 
Ignition timing locked out at 30º 
Meziere electric water pump, 160º thermostat 
Milodon 8 qt. pan with single line static pickup 

See my website for complete specs and photos 
PTC 9-1/2" converter, set up for 4,000 stall (never checked it) 
B&M deep cast aluminum trans pan 
CSI carbon fiber shield 

PST 46-1/2" mild steel 
1350 u-joint in front, 1330 u-joint in rear 

Rear axle: 
Richmond 4.10 street gears 
Trac-Lok posi 
Strange S/T 35 spline axles 


Front: single adjustable coil-overs with 500 lb. springs 
Rear: double adjustable coil-overs with 110 lb. springs 
Ladder bars set neutral (bottom bar parallel to the ground) 

Car has been scaled, but when it had the old rollcage. Then, it weighed 3,150 lbs. without me (curb weight). 
Front 58%/rear 42% (yes, it's nose heavy. Don't expect to carry the front end!! ) 
Best incrementals: 
60' 1.36 
1/8 5.86 
mph 119.18 
1/4 9.16 

This was in 85º air, coasting the last 150 feet, with a rookie driver behind the wheel.  

If you're not going to use the water/alky injection system, then I would suggest disarming it by unplugging one or more wires from the pressure switch located behind the blower. It's that weird looking thing with some flimsy white plastic on it. 
My linelock wires have a weatherpack connector, and plug into the back of the steering wheel. 
Water pump and cooling fans are on manual switches only. So, turn on the water pump when you fire up the engine. I usually turn the fans on when the engine temp hits 180º. 
When the engine is cold, give it two half pumps of the gas pedal, take your foot off the pedal, hit the start button and rotate the engine a couple times then hit the ignition. Pedal it to keep the revs up , until the engine warms up enough to maintain an idle. 
I made my passes with the back tire pressure set at 10 lbs. It hooked up well, and gave good stability down track. 
I shifted at 7,200 rpm. I don't know what rpm it crossed the stripe at, I was too busy hangin' on and looking straight ahead!! 
I lash the valves at .014 cold. 
It never hurts to install a fresh set of sparkplugs. I gapped them at .035. 
That's all I can think of right now. If you have questions, just ask me. 
Body has a few imperfections front bumper is in primer.  Roll bar was cut so my friend could get in at his age Was my friends car that passed away

Payment Details

TradesNot Accepted
Accepted Payment Methods Cash

Message Seller

Send Message

About The Seller

Member Since July 2006
sicklerville, NJ 08081
(856) 278-0662
Honor Payments
Lifetime: 0
Last 12 months: 0 Learn More
No Achievements Yet
Bronze Seller Silver Seller Gold Seller Platinum Seller Power Seller
Get Transportation Rates


View All Resources

Buyer Resources

Similar Classifieds
Copyright © 2005-2019 MH Sub I, LLC dba Internet Brands All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy